Heinz I think you are working. I have the ref1 and ref 0 crystal unit and when operational thats the way the LEDs work. On my unit the system locks in 15-30 minutes from a cold start.
On start up the LEDs should step. Then the top 2 should turn on. No gps and fault 15 minutes later fault of green on 2-5 minutes later no gps off. The ref zero aligns to the Ref1. If Ref 0 fails 1 will turn green. Good luck Paul WB8TSL On Sun, Aug 16, 2015 at 7:01 PM, Heinz Breuer <[email protected]> wrote: > Hello, > I am new to GPSDO and a new member to this list. > > I bought a Lucent/Symmetricom Z3810AS from the source on eBay and powered > it up today for the first time. After 11 hours the RFTG-u and REF1 module > is still showing "STBY" while the RFTG-u and REF0 module is "ON". > Is this ok or should the RFTG-u and REF1 module show "ON" also? > > I am in Germany and currently use an indoor GPS antenna directly behind a > large window facing west. Do I need to put the antenna on the roof or wait > even longer? > > I did not try to connect a PC to get any status info because I am no > computer wizard. In fact I have two left hands regarding computers. > > I want to use the 10MHz output as a reference for my home lab and feed > several frequency counters etc. I probably need to build a distribution > amplifier and would appreciate any hints. > > vy 73 Heinz DH2FA, KM5VT > > Von meinem iPhone gesendet > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
