Arthur, I did read your posts before I composed my email. You made no mention of getting the RS-232 to work, and you made no mention of the MACT switch. Yours worked from the start. I am not having such good luck.
I got it to lock once, I notice the 1pps comes out almost immediately, even after being off overnight. I thought this output was a result of GPS lock and this locked in less than 10 seconds. So in my case, it still has locked only once, and I don't see anything coming out of the serial port, so it's difficult to make any other evaluations. The green activity light is on solid then after the oven reaches temp (the current draw goes down) the light starts blinking. The output from the oscillator is there, so I will X-Y it with my Z3805A and see if the oscillator is truly locked to GPS. Bob >>> -----Original Message----- >>> From: time-nuts [mailto:[email protected]] On Behalf Of Arthur >>> Dent >>> Sent: Saturday, September 12, 2015 11:38 PM >>> To: [email protected] >>> Subject: [time-nuts] Trimble GPSDO board >>> >>> "Did anyone have any luck in talking to this unit?" >>> >>> Reread my posts that describe what I did. Mine works great. >>> >>> -Arthur >>> _______________________________________________ >>> time-nuts mailing list -- [email protected] To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> ----- >>> No virus found in this message. >>> Checked by AVG - www.avg.com >>> Version: 2015.0.6140 / Virus Database: 4419/10627 - Release Date: >>> 09/12/15 _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
