On 14 September 2015 at 15:37, Mike Cook <[email protected]> wrote:
> > Hi, > I have both -T and SMT and have not seen this on the 5th or afik any > other day. If you have other dates, I can check those in more detail. > OK - I think this itself excludes an issue with the boards. What firmware are you running on the T's: 1.17, 1.14 or something else? > I would suggest that if you have spare capacity, that you remove one of > the receivers from its platform and monitor with it hooked up > independently. If it is shows no issue then you can go back to the vendor > with the evidence. > Thanks Mike - I didn't mention in the original e-mail that I am not in a position to remove the receivers as these are boxes under support / warranty, even the lab ones I test with. I was trying to establish if this is a Trimble issue, because the vendor tends to have little clue. Long story. Also since I can't remove them, I can't check their firmware. I have some standalone Resolution T's at home, but I don't have them operational 24/7. I should probably fire them up. Best regards, Wojciech _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
