On 10/19/2015 11:51 PM, Richard (Rick) Karlquist wrote:
The thermal fuse plugs into pin sockets. It cannot be
soldered for the obvious reason that the solder
would melt it...at 109 degrees as it is marked.
My suggestion would be to jumper it out of the circuit.
However, if you'd rather have some small degree of protection against
meltdown due to the thermistor failing open, a good replacement which
fits is available for less than $1 from Digikey: EYP-1BF115.
This was discussed about a year ago at some length.
Dan
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
