Hello all,
I have a Pendulum CNT-90 with the standard oscillator option. I notice that there is an open area on the main PCB where a higher stability reference would be installed. 1) Is it possible to install an aftermarket high stability reference oscillator into this stock CNT-90 and be able to use it? 2) If so, is it just a matter of soldering an appropriate OCXO module into the designated area on the PCB? 3) Will the CNT-90 automagically recognize it, or are there jumpers or other things that have to be done to enable it? 4) Any recommendations for a good, high stability reference to use? Thanks, Stan _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
