Hi You may have cleaned up a dirty pot wiper as well …
The SR620 has X/Y outputs? Who knew? … that’s how often that feature gets used around here. Bob > On Feb 23, 2016, at 12:14 AM, Joseph Gray <jg...@zianet.com> wrote: > > Ignore the problem with EXT trigger. I did a factory reset and now it > is working. I should have thought to reset it to begin with. > > Joe Gray > W5JG > > > On Mon, Feb 22, 2016 at 8:14 PM, Joseph Gray <jg...@zianet.com> wrote: >> Finally got an SR620 at a decent price. I'm going through the >> Functional Tests and the Performance Tests now. So far, I have two >> anomalies. >> >> Pg 62 Functional Test - EXT input. When I vary the EXT trigger knob, I >> don't get the trigger LED, except that it flashes briefly at one spot >> as I move the knob from high to low. >> >> XY outputs - text at the top is slanted and text near the middle right >> is overlaid. I don't know if I care about this, as I am unlikely to >> use this feature. >> >> I can't test the printer port. No Epson printer. I probably don't care >> about this, either. >> >> Pg 63 Performance Test - Timebase frequency is 15 Hz high. I will adjust >> later. >> >> Timebase accuracy +/- 0.0035 Hz passes. >> >> This is far as I have gotten. After I get a bite of dinner, I will proceed. >> >> The EXT trigger test not working worries me. Perhaps I am doing something >> wrong? >> >> >> Joe Gray >> W5JG > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.