Ulrich, The connectors can be obtained reasonably inexpensively from Galco.
http://www.galco.com/shop/Circular-Connectors They are a 3 pin circular connector, consisting of three parts, that are purchased as an 'insert', 'shell', and 'clamp', IIRC. I don't have the part numbers in front of me but they are the same for the 5061 Cesium standards. I can get you the specific part numbers if you can't find it in the archives. I used a spare 3 wire extension cord and just cut the end off the cord and installed the connector to mate with the 5065A and 5061A. I've been told that the wiring is different between the 5061A and some of the 5065A's but I've never found a 5065A that was different from my 5061A. Might want to open the unit and make sure the wiring matches the schematic. Good luck. Joe -----Original Message----- From: time-nuts [mailto:[email protected]] On Behalf Of KA2WEU--- via time-nuts Sent: Thursday, March 17, 2016 9:30 AM To: [email protected] Subject: Re: [time-nuts] Fw: 5065 The HP 5065A Rubidium Frequency Standard requires a circular 3 pin adapter cable that can be plugged into 115V AC outlet. I checked all cables I have and this particular cable is not finable. Can the unit set to 110/220 V Maybe this cable can be purchased or assembled ? ULRICH _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
