Hi The board is pretty non-critical. It’s 90% audio. The biggest hassle is a power supply. You would *like* a fairly high voltage, at least if you are driving a spectrum analyzer. That may not be quite the case with a sound card. It depends a *lot* which one you are running. Something like a QA401:
https://www.quantasylum.com/content/Products/QA401.aspx Would make a good target device. It’s based on the AKM 5397 So might some Janus boards. They are based on the earlier(?) AKM 5394. The QA401 has the advantage of a nice box and full USB isolation (ground loops are a pain). It also has drivers and all the OS hooks. The Janus is a bit more “DIY” with no drivers or interface (let alone isolation). The Janus is < 1/4 the price. The high voltage (+/- 18V linear regulated) supply approach makes a lot of sense with the QA401. It probably does not make as much sense with the Janus. Switching regulators of any sort are something I would strongly recommend against in a system like this that is trying to measure noise floor at audio …. The schematic changes a bit depending on what the target is. I can draw it up if there is a consensus on the target. One example: If the “sound card” is DC coupled, you can use it to indicate (and check) quadrature. If it’s an AC device, you need some sort of isolated output for another indicator. Bob > On Mar 24, 2016, at 1:31 PM, John Ackermann N8UR <[email protected]> wrote: > > I'd be willing to assist with board layout if someone wanted to make this > into a real project (e.g., fully developed schematic). TAPR might be talked > into supplying at least bare boards; we'd have to get a sense of demand > before committing to a full kit or assembled unit. > > John > ---- > On 3/24/2016 9:04 AM, jimlux wrote: >> More like $40 in parts, without a board, etc. >> The RPD-1 is $20.70 >> LT1678/LT1679 is a nice low noise opamp that does rail to rail and is >> about $5 >> etc >> >> >> >> On 3/24/16 4:42 AM, Bob Camp wrote: >>> Hi >>> >>> Pretty simple: >>> >>> Double balanced mixer, RPD-1 is one option, there are others. >>> >>> Fairly simple L/C lowpass between the mixer and an op-amp. >>> >>> 20 db positive (non-inverting) op-amp amplifier string after the mixer >>> >>> Output of the string goes to the sound card. Use a good (dual / quad) >>> audio op amp >>> >>> Quadrature amp picks off the output of the first op amp stage, switch >>> and resistors to set gain, pot to set op point. >>> >>> ==== >>> >>> So what you have is an old style quadrature phase noise amp and “PLL”. >>> More or less a very junior version >>> of the 3048 test box. Like any setup of this sort, you check two >>> similar oscillators. They run in quadrature and >>> you do a few “measure this with switch in position A” sort of things >>> to set things up each time. >>> >>> Nothing exotic. >>> >>> Bob >>> >>>>> >>>> >>>> Any documentation on this $40 phase noise test set? >>>> >>>> Rick N6RK >>> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
