I had some of these boards made: http://openbsc.osmocom.org/trac/wiki/osmo-lea6t-gps from the Gerbers in the git repo. I'm running the cheaper LEA-6S modules for prototyping but the boards seem to work well and were designed for the pin compatible LEA-6T you're after.
On 25 May 2016 at 23:30, Keenan Tims <kt...@gotroot.ca> wrote: > I had some of these boards made: > http://openbsc.osmocom.org/trac/wiki/osmo-lea6t-gps from the Gerbers > in the git repo. I'm running the cheaper LEA-6S modules for > prototyping but the boards seem to work well and were designed for the > pin compatible LEA-6T you're after. > > On 20 May 2016 at 01:27, Angus <not.ag...@btinternet.com> wrote: >> >> On Wed, 18 May 2016 05:31:45 +0000, you wrote: >> >> >There is what looks like a decent carrier board for Ublox modules on >> >OSHPARK.COM's shared project library. It has a voltage regulator and >> >RS-232 interface on it... would be nicer if it had a prototype area and >> >swoopty PPS driver, but I'm too lazy to lay out a better one. Three >> >boards will cost you $30. >> >https://oshpark.com/shared_projects/8QR7ymk8 >> >> Just in case anyone thinking of it has not noticed - that one is for >> the smaller NEO version rather than the LEA version. >> >> So if anyone knows of a LEA version, or has one that they want to >> upload or whatever... ideally with sawtooth correction :) >> >> Angus. >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
