Thanks much, I'll see how it looks tomorrow. 73 es HH, Dick, W1KSZ
-----Original Message----- From: time-nuts [mailto:[email protected]] On Behalf Of EB4APL Sent: Tuesday, November 29, 2016 7:46 PM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] Thunderbolt Schematic Hi, I have a cousin of the Thunderbolt, The Trimble Nortel NTGS50AA. I have a partial schematic that includes the 10 MHz output circuit that I will attach in the hope it can be done. Hopefully both have something similar. Regards, Ignacio, EB4APL El 30/11/2016 a las 2:30, Scott Stobbe escribió: > If the unit is low on amplitude, there isn't likely much more than a > buffer amp between the ocxo and 10 MHz output. > > On Tue, Nov 29, 2016 at 7:54 PM Bob Camp <[email protected]> wrote: > >> Hi >> >> There is no schematic for the TBolt available. Based on Trimble’s >> approach to keeping all their IP private (look at the survey side …), >> there will not be a schematic coming out from them. Since a good >> chunk of the functionality is in the FPGA’s and CPU’s, a schematic >> may be a tough thing to come up with by tracing this and that on the board. >> >> Bob >> >>> On Nov 29, 2016, at 6:38 PM, Richard W. Solomon >>> <[email protected]> >> wrote: >>> From the last e-mail I saw in 2014, there was no schematic available. >>> >>> >>> >>> Has anything changed lately, is one available ? >>> >>> >>> >>> I have one with low output that I would like to take a crack at fixing. >>> >>> >>> >>> Thanks, Dick, W1KSZ --- El software de antivirus Avast ha analizado este correo electrónico en busca de virus. https://www.avast.com/antivirus _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
