Hi

> On Dec 19, 2016, at 9:30 PM, Charles Steinmetz <[email protected]> wrote:
> 
> David wrote:
> 
>> This does appear now to be working - see below. I'm not exactly sure what
>> was the secret to getting this to work, but the above procedure seemed ok.
> 
> Time.  It is not at all unusual for a 58503A that has no almanac (or an 
> out-of-date almanac) to take several days to achieve disciplined operation 
> (and much longer for the OCXO to fully stabilize).  You may get lucky and 
> find that it happens faster, but don't count on it.  FWIW, HP GPSDOs often 
> take longer than others to initialize.
> 
> Everyone, please remember -- GPSDOs can take significant time to 
> re-initialize.  No need to post about what may be wrong until at least 3 days 
> of continuous running after powering on.  Chill.
> 
> Same with respect to crystal oscillators settling to low drift rates. No need 
> to worry about drift (retrace) for at least a month (sometimes 6 or even 12 
> or 24 months) of continuous running after powering on.
> 
> Honestly, the best thing to do is turn it on and forget about it for 3 days 
> (GPSDO) or 1 month (crystal oscillator).  DO NOT observe it (log it, if you 
> feel the need, and don't look at the log until after the 3/30 days).

….. and that’s several days with constant access to satellites (> 6 sats at all 
times). If your antenna location is “challenged” you can multiply the time 
required by some factor like 3 or 5 or …
This is why some of us spend a lot of time talking about the importance of 
antenna location on these boxes. 

Bob

> 
> Precise time and frequency require patience!
> 
> Best regards,
> 
> Charles
> 
> 
> _______________________________________________
> time-nuts mailing list -- [email protected]
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to