I like the Bosch BME280 conneced to a Raspberry PI. https://learn.adafruit.com/adafruit-bme280-humidity-barometric-pressure-temperature-sensor-breakout/pinouts https://github.com/adafruit/Adafruit_Python_BME280/blob/master/README.md -- Björn Sent from my smartphone. -------- Original message --------From: Bob Camp <kb...@n1k.org> Date: 03/01/2017 19:36 (GMT+01:00) To: Discussion of precise time and frequency measurement <time-nuts@febo.com> Subject: Re: [time-nuts] Temperature (environmental) sensors Hi
There’s always the “cool factor” of higher resolution. Apparently it’s not enough of a issue to make it a worthwhile market to serve. Based on what has been tossed around, it sounds like an Arduino with some bits plugged in is the low cost leader. 3D print up and enclosure and you have it all in a some large form factor. Bob > On Jan 3, 2017, at 12:54 PM, jimlux <jim...@earthlink.net> wrote: > > On 1/3/17 9:15 AM, Bob Camp wrote: >> Hi >> >> There is an ever increasing pool of good sensors to put into something like >> this. >> (More so for temperature and pressure. Humidity still is a bit of an issue.) >> There’s not a lot to interface between the sensor and a USB “chip”. It’s >> surprising >> that there aren’t more cheap / high accuracy choices out there. >> > > > the market probably isn't there for a cheap "pod" with an interface and high > accuracy.. > > The Lascar units (and similar $100-ish ones from others) meet most of the > existing need fairly well (e.g. monitoring the temperature of your freezer > for FDA regulatory compliance, monitoring the temp and humidity in your ESD > controlled space).. > > The need for 0.1 degree C room temp measurement is, I think, fairly limited > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.