I have a '50AA here. But I don't use any command line options relating to
box ID. Just start up LH - LH talks to the box, determines it's a Trimble
variant, and off to the races it goes.
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
-----Original Message-----
From: Peter Reilley
Sent: Thursday, January 05, 2017 12:11 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] No sat positions in LH with Trimble NTBW50AA?
I tried /rxt but that won't communicate. Must I put the unit in
Thunderbolt mode? Is there
a jumper or a command that will do it? The manual that I have does not
mention different
modes. It only talks about SCPI.
Thanks,
Pete.
On 1/5/2017 12:41 PM, Mark Sims wrote:
The Nortel devices can talk either as a Thunderbolt or as a SCPI device.
Use it as a Thunderbolt (/rxt). In SCPI mode the satellite positions are
polled for once a minute (at xx:xx:33). Thunderbolt mode provides much
more and better control of the receiver.
---------------
I just got my Trimble NTBW50AA GPSDO up and running with Lady Heather
5.0.
However I don't see any satellite data as I do with my Resolution T. I
am using
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
