Hi Bob,
There is also the A20 board for the C-channel consisting on a series of
attenuator, amplifiers/limiters and a divide by 4 before reaching that
SMA connector. You then flip the option switching on the motherboard.
I got the C-channel on mine, but you should be looking into
05372-90016.pdf which is the service manual, chapter 12.
If you have a replacement board that does the same operation, you can
enable the C-channel without too much effort as you install it.
Cheers,
Magnus
On 01/07/2017 02:26 AM, Bob Bownes wrote:
While I had the 5372a apart today to replace the battery, I noticed that there
is an SMA for channel C on the events board and diagram showing a cable from
there to the front panel.
This suggests to me that the upgrade is a cable and a key, jumper, or memory
setting.
Anyone ever done the upgrade?
Bob
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
