Hi On something like a 500’ spool of coax, the question will always be “what temperature is it where in the spool”. A single sensor will only give you precise information if the temperature ramp is *very* slow (as in days …).
Bob > On Apr 18, 2017, at 11:50 AM, Mark Sims <hol...@hotmail.com> wrote: > > Unfortunately I did not have the ability to log temperature at the time I did > that test. I just added support to Lady Heather for an environmental sensor > so I should be able to do that later on. Currently my environmental sensor > code only does two channels of temperature. I am going to build a board with > an ATMEGA 328 chip and BMP280 for humidity and pressure along with support > for a couple of temperature sensors (should be able to do type K > thermocouples and RTD1000's) > > ----------------- > >> maybe you can recalculate your results in PPM and plot against temperature, > to compare with the mw-journal plots? > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.