Corby Unless you have the tubing and plates machined flat they will leak as the tubing sides are not guaranteed to be flat and parallel wrt each side and aluminum plate stock is not flat unless you purchase 'tooling plate' which is ground parallel on both sides
So creating a seal is problematic at best Content by Scott Typos by Siri > On May 19, 2017, at 4:23 PM, <[email protected]> <[email protected]> wrote: > > Thanks everyone. > > Not looking for a redesign, just figuring out how to get the holes > drilled and tapped. > > I have come up with a scheme that looks promising and will let you know > how it goes. > > The enclosure only has to hold +.1PSI of dry nitrogen without leaking. > > It will have a pressure sensor inside to allow long term monitoring. > > From the feedback and some research I will be reducing the depth of the > threaded portion. > > Cheers, > > Corby > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
