Jerry, Greg is referring to the adapter cable to split the power and pps out of the DB9.
There may be enough interest to do a small second round. The prices would be higher due to the lower quantity. I'll give it some thought while I'm on my short overseas assignment June 4-11. Happy Memorial Day, everyone! Steve WB0DBS > On May 27, 2017, at 4:14 PM, Jerry Hancock <[email protected]> wrote: > > Greg, to which adapter cable are you referring? From the PC to the DB9? > > What I did in the meantime was use breadboarding jumpers. The square female > ends typically will press onto the DB9 male pins. > > Glad they fit your need. > > Steve, sounds like there won’t be another round? > > Jerry > > >> On May 27, 2017, at 2:04 PM, Gregory Beat <[email protected]> wrote: >> >> Steve and Jerry - >> >> Thank you for coordinating the acquisition and machining of these End Panels >> for the TAPR GPS Experimenters Kit. I understand these kits (SynPaQ/E >> version XTS) are EXHAUSTED at TAPR. Check the TAPR web site for details. >> https://www.tapr.org/gps_exp-kit.html >> >> The End Panels arrived from Jerry this afternoon (Saturday, USPS Priority). >> They were well packed and I found no oil on my end panels. >> >> The VCC lens cap and >> http://www.mouser.com/ProductDetail/VCC/CMS322CTP/?qs=YfTKvZjIiZx%2FK6G184oH6A%3D%3D >> Retaining ring (Mouser) for Front Panel LEDs fit perfectly. >> http://www.mouser.com/ProductDetail/VCC/RNG_268/?qs=%2fha2pyFaduhfGvQXQvy97Y4tfuHua2s5JninzMNF16XefMczA6YdRg%3d%3d >> >> The TAPR kit does not include the "jack screws" for the DE-9 connector. >> I had these in my parts drawer, Jameco part number: 16548 (75 cents/set). >> http://www.jameco.com/z/14-522-R-Jack-Screw-Nut-Washers-Set-4-40-Hex-0-187-W-x-0-187-H-x-0-315-L-Thread_16548.html >> >> The kit Looks Great (like new). Now to build the Adapter Cable this weekend. >> https://www.tapr.org/images/com-cbl.jpg >> >> greg, w9gb >> >> > Subject: [time-nuts] GPS Kit Plates >> > >> > Hello again, fellow curmudgeons, >> > >> > I sent out more shipping notices this morning and plan to hit the PO in >> > about 5 hours. >> > >> > When you receive your plates and prior to mounting, please clean them with >> > soap and > water or even windex or simple green. I cleaned the machine >> > oil off to the limit of my > patience but there might be a little left. >> > I’ve not seen any interaction between the >> > machine oil, windex, etc with the coating. >> > >> > Regards, >> > >> > Jerry >> >> >> >> Sent from iPad Air > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
