Mark, Have you built a special version of LH to work with the RFTGm’s? If so, is it possible to get a copy?
Thanks, Rodger > On May 28, 2017, at 2:15 AM, Mark Sims <[email protected]> wrote: > > I have Lady Heather working fairly well with the RFTGm's. I used a serial > port monitor program to capture the traffic in and out of the serial port and > used the Lucent control program to set and read various parameters. By > analyzing the captured traffic and comparing the results to what the Lucent > program was reporting / sending I worked out the protocol and message formats. > > The one message that I have problems with is the one that reports the EFC DAC > voltage and temperature. The message appears to be reporting the DAC value > and temperature as a 16 bit integer. Scaling that to actual values could be > a problem. The DAC is not that big a deal... I scale it to a 0-100% value... > no real need to be concerned with the actual voltage. The temperature value > will require a lot of work. It has an 8 bit granularity and seldom changes > more than one step. > > One annoying thing about the RFTGm's is that they don't report satellite > positions (just signal levels)... so no nice antenna survey maps are possible. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
