Have you tested this approach? The firmware will need to recognize the new hardware configuration to enable the 250's additional sync input options and I'm not sure how just adding jacks would be something that could be sensed reliably by the chipset?
Thanks Philip -----Original Message----- From: time-nuts [mailto:[email protected]] On Behalf Of [email protected] Sent: Tuesday, October 03, 2017 4:25 PM To: [email protected] Subject: [time-nuts] S200 to S250 Conversion to in/outs Quite easy to accomplish! Signals 1PPS and 10mHz are sitting untapped at the jack signal traces on the board. You could put any 50 ohm BNC jacks there. However here is the correct dual jack part to install (3 req'd). Search Digikey for their part# ARF2115-ND Voila! Instant S250 !!! all the gozintas, and gozoutas. Hope this has not already been discussed! Martin _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
