I have finished my breakout boards for the X72 oscillator. It consists of two
boards connected by a ribbon cable (or you can remove a header and replace with
a female and directly connect them or solder the boards together). Power
input is through a 2.1mm barrel connector. Input caps are rated at 25V, so a
max 15V input is suggested. You can power it via either board... the
connections are in parallel.
The first board is a small interface board board that plugs into the X72 and
breaks out all 26 connections to a 2x13 pin 0.1" pin header. It also has
connections for the SERVICE, LOCK, and 1PPS signals driven through 1K
resistors... can be used to drive LEDs, etc. Note the 1PPS signal would need
to be stretched to drive an LED and the LOCK polarity is such that LOCK is
indicated by the LED being off.
The second board is a breakout board that has an RS-232 interface (with
selectable 1PPS polarity signal and optional raw/5V regulated power signal
available). It also has BNC connectors for the 1PPS IN, 1PPS out, EFC IN, 10
MHz output, and selectable user programable ACMOS frequency output / FXO 60 MHz
oscillator output. The breakout board also has
The boards are assembled and include a 200 mm long ribbon cable (photo shows a
shorter cable. The price is $25 per set shipped in the US. Overseas shipping
is an additional $10 for any quantity. Contact me off list if interested.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
