The reference was a 5 MHz Wenzel ULN and the instrument was a Miles TimePod.
On Jan 28, 2018, 8:13 PM, at 8:13 PM, Jerry Hancock <[email protected]> wrote: >John, what device did you use for the test? > > >Regards, > >Jerry > > >Jerry Hancock >[email protected] >(415) 215-3779 > >> On Jan 28, 2018, at 4:23 PM, John Ackermann N8UR <[email protected]> >wrote: >> >> I received the Si5340A evaluation board from Digikey on Friday and >fired it up yesterday. I used the SiLabs "ClockBuilder" software to >configure four outputs -- 10 MHz, 15 MHz, 29.999 999 9 MHz, and 144.2 >MHz -- all using the 45 MHz crystal that comes with the EVM. Attached >is a phase noise plot of the 10 MHz and 29.999 999 9 MHz signals. I >would say this isn't too bad! This performance is certainly sufficient >for any of the RF work I have in mind. >> >> The ADEV was another matter -- about 1e-9 at 1 second, working its >way uphill from there. But what do you expect from a bare crystal? >> >> John >> >> <siLabs5340-test.png>_______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > >_______________________________________________ >time-nuts mailing list -- [email protected] >To unsubscribe, go to >https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
