Should say 1.7 nsec we also plan to use the GCLK output for what I call a GPS PLL we have done it successfully with low cost u-blox with E-11 frequency results. Bert Kehren In a message dated 5/21/2018 7:49:20 AM Eastern Standard Time, time-nuts@febo.com writes:
Our answer was real time correction, see attached, just received boards for Furuno BT-87, with a specification of 1.7 msec. saw tooth, we do not plan on any additional processing.We have experience with Ublox up to 7 but have spend no time on 8, waited on availability of the 87. Digi Key wants $ 100 but found them half that price in Germany. Has any body found a lower price in the US? Bert Kehren In a message dated 5/20/2018 11:12:05 PM Eastern Standard Time, g...@rellim.com writes: Yo Mark! On Mon, 21 May 2018 03:04:23 +0000 Mark Sims <hol...@hotmail.com> wrote: > The sawtooth value is in the 0x0D-0x01 (TIM-TP) message. Third > value, called qErr. 32-bit dword. In picoseconds. How do I feed that into my TICC in real time? RGDS GARY --------------------------------------------------------------------------- Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703 g...@rellim.com Tel:+1 541 382 8588 Veritas liberabit vos. -- Quid est veritas? "If you can’t measure it, you can’t improve it." - Lord Kelvin _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there._______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.