Hello, Time-Nutters---- I recently updated an old version of Lady Heather that has been running well 24/7/365 for a number of years (except during prolonged power grid outages !). V5.0 is now installed and running. Getting it to display full-screen takes a bit of fiddling with different commands but otherwise seems to be running OK.
I do have a number of questions about V5.0 but one I am focusing on at the moment is the command to enable the millisecond digits for the time display. The info I have says this is done by entering the /TSZ command. However, when entering this command the three millisecond digits do appear but only alternate back and forth every several seconds between "052" and "053". What might I be doing wrong? Any suggestions on how to make the millisecond digits count and sequence correctly? Thanks for any suggestions on resolving this issue !! Mike Baker Micanopy, FL ********************* _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.