16 MHz VCO divided by 16 to 1 MHz; 10 MHz divided by 10; Phase detector and
loop filter to control the 16 MHz VCO.
Regards,
Tom
----- Original Message -----
From: "Tom Van Baak" <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Saturday, September 29, 2018 11:57 PM
Subject: [time-nuts] 10 MHz -> 16 MHz
What's a clever, simple, reliable (pick 2 of 3) way to get 16 MHz out of
10 MHz? Low phase noise isn't a big requirement and jitter doesn't need to
be sub-nanosecond. The main requirement is perfect cycle count accuracy.
This is for driving a 16 MHz microcontroller from a 10 MHz Rb/Cs/GPSDO. 10
MHz input is likely sine; 16 MHz output is 3v3 or 5v CMOS.
Thanks,
/tvb
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
