Chris, Check that you have configured the pulse width and period/frequency switches correctly. Please post the result of UBX-CFG-TP5 query on TIMEPULSE2 here. If you are putting Ublox into SAFEBOOT mode you'll see it right away - all navigation tasks are shut down in this mode. Leo
> From: Chris Wilson <[email protected]> > I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on > TP2. If I programme it with the UCentre software for say 500hZ output > I sill see nothing on TP2. Do I need to pull it high on boot or > anything to see an output please? I am not probing it with a X10 scope > probe until after it has booted, so I don't believe it's pulled low on > boot, although I can't see how a X10 probe setting could pull it > anyay. TP0 behaves normally and accepts changes in output frequency. > Otherwise it also seems to generally act correctly. Thanks _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
