Hello Leo I thank you for the reply. I am away from the device until tomorrow but I did take these screen shots a while ago, but I am not sure if they cover what you are requesting though? Query? Is that a specific command? Please excuse my ignorance, I am new to these Ublox GPS units :)
http://www.chriswilson.tv/ublox/TP0.jpg http://www.chriswilson.tv/ublox/TP2.jpg Friday, January 18, 2019 Best regards, Chris mailto:[email protected] LB> Chris, LB> Check that you have configured the pulse width and LB> period/frequency switches correctly. LB> Please post the result of UBX-CFG-TP5 query on TIMEPULSE2 here. LB> If you are putting Ublox into SAFEBOOT mode you'll see it right LB> away - all navigation tasks are shut down in this mode. LB> Leo >> From: Chris Wilson <[email protected]> >> I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on >> TP2. If I programme it with the UCentre software for say 500hZ output >> I sill see nothing on TP2. Do I need to pull it high on boot or >> anything to see an output please? I am not probing it with a X10 scope >> probe until after it has booted, so I don't believe it's pulled low on >> boot, although I can't see how a X10 probe setting could pull it >> anyay. TP0 behaves normally and accepts changes in output frequency. >> Otherwise it also seems to generally act correctly. Thanks LB> _______________________________________________ LB> time-nuts mailing list -- [email protected] LB> To unsubscribe, go to LB> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com LB> and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
