Taka Kamiya wrote:
I am thinking about distribution amplifier of a sort. Not a kind with 8 or
more output but just 2 or 3.
* * *
But how do I do this on 10MHz side? I'd like to have minimal distortion (sine
wave) and high isolation. I acquired a few signal splitter and monolithic
amplifiers. Split first and amplify? Amplify first and split? Remember it's
only 2 to 3 channels. Amplifier module has too much gain, so I'll probably
have to use attenuators.
Have anyone run into this kind of thing? Is there an existing design?
Anything anyone would like to share?
I have previously posted some documents you may find helpful:
<http://www.ko4bb.com/manuals/73.134.121.2/Tutorial_Distribution_Amplifier_Architectures_STEINMETZ_rev1.pdf>
<http://www.ko4bb.com/manuals/73.134.121.2/Extron_ADA_6_modifications_for_use_as_10MHz_distribution_amp_STEINMETZ.pdf>
The first one is a general tutorial on sine-wave distribution amplifiers
that describes the various approaches and provides generalized design
details.
The second one is a "modification manual" that gives specific
instructions for modifying one particular family of commercial 75-ohm
video distribution amplifiers (found inexpensively on eBay) for optimal
use as a 1MHz to 100MHz sine wave distribution amplifier [with way more
outputs than you say you need -- but note that you may find your "needs"
develop and expand if you have more outputs.]
Finally, consider carefully how much isolation you really need. There
are two basic kinds of "distribution amplifiers". The first is what the
term is generally used for, while the second ("isolation amplifiers") is
a specialized subset of distribution amplifiers with specific, enhanced
performance requirements.
Distribution amplifiers are intended to provide high-quality output
signals to a number of instruments (e.g., a frequency counter and a
spectrum analyzer) simultaneously. However, they are not expected to
have their various outputs compared differentially or
interferometrically with respect to delay time (phase), harmonic
content, noise, etc. Output isolation figures are typically from 40dB
to 80dB.
Isolation amplifiers must be used when such comparisons are to be made,
for example sending two copies of a signal down different paths and
comparing them differentially or interferometrically at the downstream
ends -- for example, to determine the residual phase noise of devices
under test). These techniques are capable of much greater resolution
and are used to compare signal parameters at levels very close to the
metrological (or even the physical) limits, so much greater fidelity
between the two initial copies is required. Isolation should be at
least 125dB at the fundamental and first 11 harmonics, with other errors
(phase noise, harmonic distortion, etc.) at similar levels.
True isolation amplifiers are therefore substantially less forgiving to
design and build than even very good distribution amplifiers, and most
of us don't need them until we have reached at least the journeyman
level of time and frequency analysis.
My personal advice is to walk before you try to run. Build or acquire a
very good distribution amplifier, and use it until your measurements are
pretty much always limited by the DAs. *Then* augment your lab with a
proper isolation amplifier.
Best regards,
Charles
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
