If it works, don't try to fix it.
In the datasheet
https://quartzlock.com/userfiles/downloads/datasheets/e10-mrx(2)(1).pdf
there is no cooling requirement specified.
I would assume that it is usually mounted on a PCB which adds some
cooling though not terribly much.
After 1 hour the case temperature should be about 45 Deg. C at 25 Deg.
ambient.
Adrian
Am 01.09.2020 um 07:15 schrieb Richard Katsch:
Hello All,
I have acquired a Quartzlock E10-MRX Rb 10 MHz standard. It appears to lock
and produce a nice sine wave that stays in phase with my Trimble Tbolt for
a time which exceeds my attention span!!!
It does however get hot in operation. As this is my first experience with a
Rb standard I don’t know whether this is normal or indicates that I need a
heat sink.
Any comments would be appreciated.
Regards
Richard Katsch
VK2EIK
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
