Hi > On Oct 24, 2020, at 7:43 AM, Attila Kinali <[email protected]> wrote: > > On Fri, 23 Oct 2020 19:32:16 -0400 > Bob kb8tq <[email protected]> wrote: > >> This book is an introduction to designing AT cut resonators. It came out >> before the SC existed. It’s very much a “starter” book on the subject. He >> would do a 1 to 3 day training session and the book was a giveaway as >> part of those sessions. > > So, you are saying between Matthys, Frerking, Rhea, Cerda and Parzen > there isn't much value in this book?
Those authors pretty much only focus on *oscillator* design. ( = electronics). Bottom is a “crystal guy”. He focuses pretty much only on how to chop up a chunk of quartz to get this or that result ( = frequency, temp coef, size, Q ). Very different areas of interest and not a lot of “crossing over” between them. So no, it you are looking to come up with an addition to your oscillator design library, go looking for a copy of one of Dr Rhode’s books rather than one by Bottom. Bob > > Cool, that helps. Thanks! > > Attila Kinali > > -- > <JaberWorky> The bad part of Zurich is where the degenerates > throw DARK chocolate at you. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
