There is another problem besides the software, if I remember correctly the FFT card resides on the computer, not on the PN9000 box. Jorge.
On Sun, Nov 21, 2021 at 9:49 AM AC0XU (Jim) <[email protected]> wrote: > I recently purchased an Aeroflex PN9000 system with the correct modules > for doing phase noise measurements. However, I haven't been able to figure > out how to get the software for this system. The only digital interface is > GPIB. > > I believe that from the factory the system came with a Dell workstation > with a GPIB card and an A2D card. I haven't seen any of these workstations > or the software for sale. I have other GPIB and A2D cards, but no software. > > If I can't get the software, then reverse-engineering the system seems > possible theoretically but could be difficult, especially since there does > not appear to be a service manual or any kind of GPIB ICD for the system. > > Advice? > > Thanks- Jim > > _______________________________________________ > time-nuts mailing list -- [email protected] -- To unsubscribe send > an email to [email protected] > To unsubscribe, go to and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there.
