hello Bryan, Runnimg LH on a *Pi is feasible without any problems. I have built such a setup myself, it lives in my shack and is based on a Samsung UCCM GPSDO (telco surplus obtained in China). The Pi in question is an OrangePi Zero running Armbian Linux. It runs an Xdesktop on top of a VNCserver. Obviously LH shows herself on that desktop ;-) This whole shebang allows running the GPSDO/OrangePi combo to run headless (i.e. without a display), one can use any VNCclient to check on LH via the network. Laptop, tablet, even a smartphone can be used to monitor the GPSDO. The OrangePi has both Wlan as well as wired Ethernet options.
Hope this makes sense, I did an article for Electron, the monthly of the Dutch VERON ham organisation. In Dutch, for obvious reasons. But can make it available if there is interest. Wilko PA1WBU > On 2 Mar 2022, at 19:21, Bryan _ <[email protected]> wrote: > > I have seen a project where ladyheather is run off a PI, suppose you could > just configure LH to display what you need. > > -=Bryan=- > > ________________________________ > From: [email protected] <[email protected]> > Sent: March 2, 2022 9:34 AM > To: Discussion of precise time and frequency measurement > <[email protected]> > Subject: [time-nuts] Re: GPSDO - GPS1300-10-1000 by RFX Ltd. UK > > Hello to all members. > > I want to add to my lab a Pi based display that would show a GNSS SV map > like the one attached to this message. > > Any suggestions ? > > Thank you ! > > Claude VA2 HDD > > > _______________________________________________ > time-nuts mailing list -- [email protected] -- To unsubscribe send an > email to [email protected] > To unsubscribe, go to and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there.
