It looks like the XO version is mounted on the PCB. But there is a VCXO
version which would run about +/- 35 PPM/3.3V typical and that's
(amazingly) available.
Since this EFT is not an on-board capability, at the moment, I'm
thinking to mount the VCXO - and associated goodies to slave it to the
10 Mhz GPSDO feed - in a separate enclosure that could allow the VCXO to
be thermally insulated. The temp swing vs. time will move very slowly
and that would allow a very damped PLL loop to apply corrections.
I've not done anything with a PLL before but I don't envision this as
being too complicated. And it would be a pretty cool project. Don't
need true "phase" lock, but rather "frequency control" without degrading
the noise characteristics of the VCXO.
73/jeff/ac0c
alpha-charlie-zero-charlie
www.ac0c.com
On 4/3/22 7:38 PM, Lux, Jim wrote:
On 4/3/22 5:09 PM, Bob kb8tq wrote:
Hi
Does the Abricon have an EFC input? If so, rigging up a PLL to lock
122.88 to 10 MHz is probably the best option.
Bob
And what about moving off the board - so you don't have to chase the
temperature swings.
On Apr 3, 2022, at 7:57 PM, Jeff Blaine <[email protected]>
wrote:
I've got a couple of Red Pitaya 122-16 SDR and want to discipline
them to an external low noise GPSDO source. Wanted to see if there
were some easy solutions that fell into this category.
For the prior generation (QS1R), I had built a homebrew OCXO based
on a custom low noise crystal from ICM and that worked great for the
125 Mhz application. Unfortunately this Pitaya is a bit removed in
Fc and ICM has been out of biz for several years now.
The RP's on-board oscillator is the respectable Abracon ABLNO 122.88
which runs about -115 dBc/hz at 100 Hz spacing and that's probably
not a limitation for the unit. Unfortunately the OSC is a bit too
sensitive to external temp and wanders around quite a lot (+/- 5
PPM) compared to the homebrew OCXO - over the annual ambient temp
range of (10-35C) (all datasheet referenced values). The Abracon
unit is mounted on the board with the FPGA and sees additional temp
range depending on other heat generation factors (FPGA loading).
I have a couple of commercial GPSDO on the bench now, so a pretty
clean 10 Mhz GPSDO reference is available now. And I've seen enough
board discussion to know that a homebrew GPSDO solution is one of
those "it's harder than it looks" things. Hence the desire just to
buy whatever is the silver bullet, as long as it does not require
too much silver. ha ha
Appreciate any suggestions. TKs!
73/jeff/ac0c
alpha-charlie-zero-charlie
www.ac0c.com
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe
send an email to [email protected]
To unsubscribe, go to and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe
send an email to [email protected]
To unsubscribe, go to and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe
send an email to [email protected]
To unsubscribe, go to and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected] -- To unsubscribe send an
email to [email protected]
To unsubscribe, go to and follow the instructions there.
