On 14/07/2010, at 9:05 PM, Hinnack wrote:

> Hi,
> 
> maybe I am blind, but how to start 2 tunnels on OSX?
> 
> using a different device I get:
> /dev/tap1 is a Generic BSD tap device
> add net 192.168.1.0: gateway 10.9.99.4
> route: writing to routing socket: File exists
> add net 10.150.0.0: gateway 10.9.99.4: File exists
> Can't bind to 0.0.0.0 port 655/tcp: Address already in use

I think you are trying to start multiple tinc daemons.
Once one daemon has started listening on port 655, you can't run more daemons 
on the same port. It's already in use.

Try what Guus suggested if you want to connect two nodes belonging to the same 
VPN.
If you're trying to make tinc join another separate VPN, you need to add 
another netname.

This link gives some good information about this scenario under the NETWORKS 
heading.
http://tinc-vpn.org/documentation/tinc.conf.5


Mike


> Unable to create any listening socket!
> Terminating
> 
> using same device I get:
> tincd 1.0.13 (Jul  7 2010 07:42:33) starting, debug level 0
> Could not open /dev/tap0: Resource busy
> Terminating
> 
> is this a problem related to unsupported Interface variable on OSX?
> 
> regards
> 
> Henrik
> _______________________________________________
> tinc mailing list
> [email protected]
> http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc

_______________________________________________
tinc mailing list
[email protected]
http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc

Reply via email to