I want to connect to two different VPNs. sudo /usr/sbin/tincd -n net1 sudo /usr/sbin/tincd -n net2
using tincd 1.0.13 I get Address already in use as above regards Henrik 2010/7/14 Mike Bentzen <[email protected]> > On 14/07/2010, at 9:05 PM, Hinnack wrote: > > Hi, > > maybe I am blind, but how to start 2 tunnels on OSX? > > using a different device I get: > /dev/tap1 is a Generic BSD tap device > add net 192.168.1.0: gateway 10.9.99.4 > route: writing to routing socket: File exists > add net 10.150.0.0: gateway 10.9.99.4: File exists > Can't bind to 0.0.0.0 port 655/tcp: Address already in use > > > I think you are trying to start multiple tinc daemons. > Once one daemon has started listening on port 655, you can't run more > daemons on the same port. It's already in use. > > Try what Guus suggested if you want to connect two nodes belonging to the > same VPN. > If you're trying to make tinc join another separate VPN, you need to add > another netname. > > This link gives some good information about this scenario under the > NETWORKS heading. > http://tinc-vpn.org/documentation/tinc.conf.5 > > > Mike > > > Unable to create any listening socket! > Terminating > > using same device I get: > tincd 1.0.13 (Jul 7 2010 07:42:33) starting, debug level 0 > Could not open /dev/tap0: Resource busy > Terminating > > is this a problem related to unsupported Interface variable on OSX? > > regards > > Henrik > _______________________________________________ > tinc mailing list > [email protected] > http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc > > > > _______________________________________________ > tinc mailing list > [email protected] > http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc > >
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
