On Tue, Jan 13, 2015 at 02:05:56PM +0100, Sven Galke wrote: > tinc 1.0.19 worked fine on Raspberry Pi as long as my Pi was connected via > ethernet cable. > > Today i changed the connection to wlan. Pi crashed. worse, it was no longer > operational, even if connected via cable. > recovery from backup before tinc was installed (yes, i had a backup ;) > > tried again. installed tinc: worked as long as connected via cable. crash > after connecting via wlan. no longer usable. > > result so far: never run tinc on rasp with wlan enabled. > > new problem discovered?
Make sure you have a very good power supply for your Raspberry Pi (get
one that can deliver at least 1.5 A, better get one that can do 2 A).
Even then, it's recommended to run the wireless network dongle from a
separate, powered USB hub. If the power usage is too high, even for a
short amount of time, the voltage can drop below levels that are needed
for the CPU and the SD card to work reliably. This is the most likely
explaination for the crashes you got.
--
Met vriendelijke groet / with kind regards,
Guus Sliepen <[email protected]>
signature.asc
Description: Digital signature
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
