Ah, fantastic. With the following config I get a usable tap0: $ sudo cat /etc/tinc/robotvpn/tinc.conf Name = elendur Mode = switch AddressFamily = ipv4 Device = /dev/tap0 Compression = 1 ConnectTo = robot_ph_cpe22_04
Still need to figure out the Avahi side of things for name resolution, but thanks all! On 26 February 2016 at 11:04, Guus Sliepen <[email protected]> wrote: > On Thu, Feb 25, 2016 at 01:55:59PM -0500, Mike Purvis wrote: > > > Here's my config: > > > > $ sudo cat /etc/tinc/robotvpn/tinc.conf > [...] > > Interface = tincdev0 > [...] > > Error while writing to Generic BSD tap device /dev/tap0: Input/output > error > > Unfortunately, on Mac OS X, tinc cannot change the name of the > interface. It's probably just tap0. Tinc should've warned about this, > but it doesn't. The solution is to remove the "Interface = tincdev0" > line from your tinc.conf. > > -- > Met vriendelijke groet / with kind regards, > Guus Sliepen <[email protected]> > > _______________________________________________ > tinc mailing list > [email protected] > http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc > >
_______________________________________________ tinc mailing list [email protected] http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
