Well, this
> /etc/tinc/robotvpn/tinc-up: line 3: avahi-autoipd: command not found
Says you don't have avahi...
What happens, if you run:
$ sudo avahi-autoipd -D /dev/tap0
?
On February 26, 2016 7:10:16 PM GMT+03:00, Mike Purvis
<[email protected]> wrote:
>Ah, fantastic. With the following config I get a usable tap0:
>
>$ sudo cat /etc/tinc/robotvpn/tinc.conf
>Name = elendur
>Mode = switch
>AddressFamily = ipv4
>Device = /dev/tap0
>Compression = 1
>ConnectTo = robot_ph_cpe22_04
>
>Still need to figure out the Avahi side of things for name resolution,
>but
>thanks all!
>
>On 26 February 2016 at 11:04, Guus Sliepen <[email protected]> wrote:
>
>> On Thu, Feb 25, 2016 at 01:55:59PM -0500, Mike Purvis wrote:
>>
>> > Here's my config:
>> >
>> > $ sudo cat /etc/tinc/robotvpn/tinc.conf
>> [...]
>> > Interface = tincdev0
>> [...]
>> > Error while writing to Generic BSD tap device /dev/tap0:
>Input/output
>> error
>>
>> Unfortunately, on Mac OS X, tinc cannot change the name of the
>> interface. It's probably just tap0. Tinc should've warned about this,
>> but it doesn't. The solution is to remove the "Interface = tincdev0"
>> line from your tinc.conf.
>>
>> --
>> Met vriendelijke groet / with kind regards,
>> Guus Sliepen <[email protected]>
>>
>> _______________________________________________
>> tinc mailing list
>> [email protected]
>> http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
>>
>>
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>tinc mailing list
>[email protected]
>http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
_______________________________________________
tinc mailing list
[email protected]
http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
