Hi I am testing running tinc in switch mode. , my topology is as follows
Site 1 (tinc-srv01) -> Site 2 (tinc-srv02) I have configured the bridge interfaces with ip addresses and able to ping between bridges. I then setup a server on each site and tested layer 2 connectivity between the two servers. Topology as follows. Server 1 - *Site 1* (tinc-srv01) -> *Site 2* (tinc-srv02) - Server 2 My ping test are as follows *Site 1* Server -ping- Site 1 (tinc-srv01) - Success Server -ping- Site 2 (tinc-srv02) - Success Server -ping- Site 2 - Server 2 - Failure *Site 2* Server -ping- Site 2 (tinc-srv02) - Success Server -ping- Site 1 (tinc-srv01) - Failure Server -ping- Site 1 - Server 1 - Failure Site 2 tinc-srv02 and server are running in a hosted environment (vmware esxi hypervisor) . while Site 1 and tinc-srv01 are running on my laptop (vmware workstation). On the server in site 2 it appears that there is no arp entries being propagated in its arp table. Is there a feature I need to enable ( ie Proxy Arp) on tinc-srv02 the arp to reach the server (site 2) ? My tinc-srv02 in Site 2 has one interface that I have bridged with tun0. Please advise? <[email protected]>
_______________________________________________ tinc mailing list [email protected] https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
