Any input? Regards Yazeed Fataar <[email protected]>
On Tue, Apr 5, 2016 at 11:26 AM, Yazeed Fataar <[email protected]> wrote: > Hi > > I am testing running tinc in switch mode. , my topology is as follows > > Site 1 (tinc-srv01) -> Site 2 (tinc-srv02) > > I have configured the bridge interfaces with ip addresses and able to ping > between bridges. I then setup a server on each site and tested layer 2 > connectivity between the two servers. Topology as follows. > > Server 1 - *Site 1* (tinc-srv01) -> *Site 2* (tinc-srv02) - Server 2 > > My ping test are as follows > > *Site 1* > Server -ping- Site 1 (tinc-srv01) - Success > Server -ping- Site 2 (tinc-srv02) - Success > Server -ping- Site 2 - Server 2 - Failure > > *Site 2* > Server -ping- Site 2 (tinc-srv02) - Success > Server -ping- Site 1 (tinc-srv01) - Failure > Server -ping- Site 1 - Server 1 - Failure > > Site 2 tinc-srv02 and server are running in a hosted environment (vmware > esxi hypervisor) . while Site 1 and tinc-srv01 are running on my laptop > (vmware workstation). On the server in site 2 it appears that there is no > arp entries being propagated in its arp table. Is there a feature I need to > enable ( ie Proxy Arp) on tinc-srv02 the arp to reach the server (site 2) ? > > My tinc-srv02 in Site 2 has one interface that I have bridged with tun0. > > Please advise? > > > > <[email protected]> >
_______________________________________________ tinc mailing list [email protected] https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
