Le 31/08/2016 à 10:47, Armin a écrit :
On 30.08.2016 17:37, Guus Sliepen wrote:
On Tue, Aug 30, 2016 at 02:38:16PM +0200, Armin Schindler wrote:
we use a meshed VPN with TINC to connect 7 offices.
Some office are in other countries and use other ISPs. The connection
between some ISPs (peering partners) are not that good. This means we
have packet loss between those direct connections.
To avoid this direct connection, I would like to tell TINC to use
a defined other host to route the packets to.
E.g.
instead of doing direct office-1 to office-2, send always packets
for office-2 to office-5 (because connection with office-5 is very
stable).
Is there a way to configure TINC to not use direct connection
for one host, but use a specified, other host for that?
You can set IndirectData = yes in hosts/office-2 on hosts/office-1, and
vice versa, to prevent it from trying a direct connection.
Note that you also should not have ConnectTo = office-2 in office-1's
tinc.conf, and vice versa, otherwise the above will not have any effect.
Understood. But this will keep tinc from doing direct only, but it may
use *any* other host to transfer the data, right?
I would like to set a specific host (with best connection) to be the
'man-in-the-middle'.
Armin
Maybe you should try with the route metric.
Play with what Guus say (indirectdata) and using different metric for
your route. Small metric for your favorite host, and bigger metric for
the other.
You have to play with the routing system, but maybe just add route to
office 2 on office 5, and say that office 5 is the GW for office 2 on
the other router.
I don't know if this will work but you can try.
_______________________________________________
tinc mailing list
[email protected]
https://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
