Hi, i wait that you can understand my poor english...
i today try use Usart0 of telosb with the computer very fast. I connect pins 2, 4 y 9 of expansion connector with the DB-9 female without MAX232 :-( In the software i try with Msp430Usart0C componet and the interfaces: HplMsp430Usart and HplMsp430UsartInterrupts, but not good. I read the reply to your message and tomorrow later the use MAX232, i will try with Msp430Uart0C component. Can you give me more help?...interfaces to use, how configurate the speed. Any suggestion is very appreciated. Thank in advance. A greeting, Juan Antonio. Andrea Labo wrote: Hi there, I need to connect my TelosB(using TinyOS 2.x) with a pc through the UART0 pins from the expansion connector. I guess I must use the max232 chip for hardware connection and need drivers to configure the connection parameter(i.e.: baud rate, length, stop bit...) and others to send and receive byte from/to Uart0. Does anyone know if there are these modules in tinyOS 2.x? Does anyone has tried it? Any suggestion is very appreciated. Thank in advance. Andrea.
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
