Hello Juan, The MEP nodes in the MEP-SYS are programmed with XMesh 1.2 firmware and the low power version of this app doesn't support the commands (eg. change data rates). You need to reprogram the MEP nodes with the newer MEP application firmware available in MoteWorks to change the data rate etc. Regards, Giri Baleri Crossbow Technology, Inc
________________________________ From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Juan Antonio López Riquelme Sent: Monday, June 18, 2007 11:33 AM To: tinyos-help Subject: [Tinyos-help] Problems with Moteview 1.4 and MEP-SYS of CrossbowInc. Hi, I am using MEP-SYS and Moteview 1.4c from Crossbow Inc (http://www.xbow.com/Products/productdetails.aspx?sid=245). I tried to change the LEDs status of only MEP410 nodes and the sample rate in all nodes (MEP410 and MEP510) using the option command in tab control. After this, I don't see any changes in the leds and data change with the same sample rate that there was before changing in the option data of tab control. Can anyone give any advice to solve this problem? PD. I received all nodes pre-programmed. thanks in advance greetings Juan Antonio.
_______________________________________________ Tinyos-help mailing list [email protected] https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
