You should get data, if not information, w/o a sensor attached.
If you are using the T1 Oscope app that goes directly to the
UART port you should see something on the PC side no matter.
Check that you are using the right port and MOTECOM variable.
I forget what platform you are on, if you have a MIB510 host-
adapter make sure the silly-slide-switch opposite the serial
conn is in the OFF position.
MS
Abdullah Kadri wrote:
I have a problem with oscilloscope application. When I run the Listen
process I do not see any traffic. And even when I open the Oscilloscope
GUI I do not see any signal. The Leds on the board are blinking and I am
using Micaz board. I do not have a photo sensor onboard. Does this
affect the process?
Abdullah Kadri, P.Eng., Ph.D. Candidate
The University of Western Ontario
Department of Electrical and Computer Engineering
Phone: (519) 661-2111 ext. 81271
------------------------------------------------------------------------
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
