hi , I am using Listen program, but some packets are received with payload 0 and some are complete. As I am increasing the Load in the network, the frequency of full pactes are dropping... what I found that once the destpan field of the received packet is changed automatically and after that all packets are received with payload 0.
I tested the code with timer firing after 128 ms, then there is improvement in the no of received packets... I don't understand where the problem is.? thanks, Poonam On 4/18/08, Michael Schippling <[EMAIL PROTECTED]> wrote: > > That's a little fast for mica2s but should be ok for devices with > the CC2420 radio. But you should see the full packet no matter what. > What are you using to look at the received messages and how are you > changing the lengths? > > MS > > Poonam Hiwal wrote: > > > Hello Everyone, > > I have one question regarding how much tinyos code take time to execute > > a application. Becaus ein my application, the timer is fired after every 32 > > millisecond and receiver node is receiving nearly 30 packets each of 40 > > bytes. It is receiving only the header of the packets not the content. but > > If I amm reducing the load, it is receiving the complete packets, I am not > > able to understand why it is happening? Is there any congestion at receiver > > (sink) or all this is due to timer. > > If anyone can help me in solving this, that would be good. > > Thanks, > > Poonam > > > > > > ------------------------------------------------------------------------ > > > > _______________________________________________ > > Tinyos-help mailing list > > [email protected] > > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > > > > -- > Platform: WinXP/Cygwin > TinyOS version: 1.x, Boomerang > Programmer: MIB510 > Device(s): Mica2, MicaZ, Tmote > Sensor board: homebrew > >
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
