hi everyone:
This is my first uploading the coding by command "make mica2" and "make
mica2 reinstall mib510,com3", the output means the operation is successful,
but a question comes out, under the Cygwin, after input the command "xserve
-device=com4", the results is following :
$ xserve -device=com4
XSERVE 2.0.E: $Id: xserve.c,v 1.8.2.3 2007/02/02 17:45:01 rkapur Exp $
Warning: Converting Windows com4 device to Cygwin device.
Using params: [raw] [parsed] [converted] [server port=9001]
Opening serial device: /dev/ttyS3 @ 57600
it seams that stop here, theorially, there should be some sychynicated or
asychynicated data if sensors are open. what is the problem, i am very worry
about whether the mib510 programming board is over by my some abnormal
operations. during these operations, i use the SW1 ("reset" button) and SW2.
I am so worry about whether wrong operation on them would bring some
problems. Have you encountered the similar situation and how to resolve it?
Would you like to give me some warm suggestions? Thanks!
Sincerely;
Maggie
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
