Hi I think that both radios are not suported in TinyOS. Saying that, you should note that CC1101 is an improved version of the CC1000 used on Mica2.
Beside that: MSP430F2274: 32KB + 256B Flash Memory, 1KB RAM I think 1KB RAM could be not enough.... Regards, André PS: There are experts on radio drivers out there, just ask the right persons :) ----- Original Message ----- From: aldo To: André Rodrigues Cc: Urs Hunkeler ; [email protected] Sent: Thursday, April 30, 2009 4:50 PM Subject: Re: [Tinyos-help] Problems with mote TI MSP430 Thank you for help, I see in the PCB a microcontroller M430F2274 of Texas Instruments and a radio chip CC2500. Also, I have another PCB with a microcontroller M430F2274 of Texas Instruments and a radio chip CC1101. Both motes are not supported in TinyOS? I'll try what you saying Urs! :-) Regards, Aldo 2009/4/30 André Rodrigues <[email protected]> Hi I think this platform is not supported by TinyOS. Regards, André Rodrigues ----- Original Message ----- From: "Urs Hunkeler" <[email protected]> To: "aldo" <[email protected]> Cc: <[email protected]> Sent: Thursday, April 30, 2009 8:00 AM Subject: Re: [Tinyos-help] Problems with mote TI MSP430 Hi Aldo, I have not heard of a mote called MSP430+CC2500. The tmote/telosb has a msp430 micro-controller and a cc2420 radio chip. If this is not a common mote, then maybe motelist will not recognize it. Most likely the mote will be accessible under /dev/ttyUSB0. To find out, you could click on the icon of the mote in the VMWare screen to disable the mote, then wait a few seconds and re-enable the mote again. The command dmesg (which shows system information from the kernel) should tell you that a new USB device was found and what device file it was assigned (as I said, most likely /dev/ttyUSB0). You could then manually specify the port where the mote is connected: make telosb install bsl,/dev/ttyUSB0 Note: I have no idea whether your mote really is compatible to the telosb platform. Cheers, Urs aldo wrote: Hello everybody, I'm trying to download the Blink application to a mote TI MSP430 + CC2500. The programming environment I'm using is XUBUNTOS 2.1 and I don't know if it's the best. Concerning to Lesson 1 of TinyOS tutorial, when I type "motelist" I don't see anything (I plug the mote before switch on the VMWare and when VMWare starts It recognize the mote). What can I do? The TI MSP430+CC2500 mote is USB. How can I download the aplication into the mote? It's a telosb platform? Forgive me my english level :). Thank you very much for advance. Aldo _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
