From tos/interfaces/CC2420Control.nc:
/**
* Set the transmit RF power value.
* The input value is simply an arbitrary
* index that is programmed into the CC2420 registers.
* The output power is set by programming the power amplifier.
* Valid values are 1 through 31 with power of 1 equal to
* -25dBm and 31 equal to max power (0dBm)
*
* @param power A power index between 1 and 31
*
* @result SUCCESS if the radio power was adequately set.
*
*/
command result_t SetRFPower(uint8_t power);
MS
BAI LI wrote:
> Hi,
>
> I went through some posts in the list and most of them talked about how
> to set the RF power in tinyOX 1.x. I am just wondering if anyone knows
> how to set the RF power level dynamically in the code instead of adding
> some flag in the makefile? I know in 1.x, i have to use CC2420Control
> interface. Thanks in advance.
>
> Regards,
> Bai
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
