Sorry, I'm a luddite. I should think that there is a similar interface in T2. Did you try searching for SetRFPower and such like?
MS BAI LI wrote: > Hi, > > Thanks for your reply. But sorry for the confusion. I mean how to do it > in TinyOS2.1 not TinyOS1.x. Thanks. > > Regards, > Bai > > On Tue, Jun 30, 2009 at 2:41 AM, Michael Schippling <[email protected] > <mailto:[email protected]>> wrote: > > From tos/interfaces/CC2420Control.nc: > > /** > * Set the transmit RF power value. > * The input value is simply an arbitrary > * index that is programmed into the CC2420 registers. > * The output power is set by programming the power amplifier. > * Valid values are 1 through 31 with power of 1 equal to > * -25dBm and 31 equal to max power (0dBm) > * > * @param power A power index between 1 and 31 > * > * @result SUCCESS if the radio power was adequately set. > * > */ > command result_t SetRFPower(uint8_t power); > > MS > > > BAI LI wrote: > > Hi, > I went through some posts in the list and most of them talked > about how to set the RF power in tinyOX 1.x. I am just wondering > if anyone knows how to set the RF power level dynamically in the > code instead of adding some flag in the makefile? I know in 1.x, > i have to use CC2420Control interface. Thanks in advance. > Regards, > Bai > > > > ------------------------------------------------------------------------ > > _______________________________________________ > Tinyos-help mailing list > [email protected] > <mailto:[email protected]> > > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
