well I thought a little bit about that and I'm thinking the problem might be because of receive hardware issue with the mote itself. but anyway I think the best way is to ask the XBow guys themselves to see what they say about it.
Thanks Michael 2009/10/15 Michael Schippling <[email protected]> > Sorry I can't help further. I've used Xmesh with only two nodes > (Base and re-Mote) to develop a sensor program so I haven't > observed the net construction behavior. I also believe the Xmesh > source is not open so you'll probably have to have a go-round > with Xbow support. > > MS > > Mohammad S. Hashemian wrote: > >> I also should include that if I wait for a long time (15 or 30 minutes) >> finally the mote becomes the member of the mesh, but this me it sends the >> health packet many times instead of once (for example 8 or 10 times) and >> therefore moteView shows 10 rows of health packet from this mote very time. >> So do you have any idea why this happens? >> >> 2009/10/14 Mohammad S. Hashemian <[email protected] <mailto: >> [email protected]>> >> >> I monitored the network at most for half an hour, and during this >> period I turned some other motes on and off as well. while those >> other motes were on, the mote was sending many copies of the health >> packets (with different sequence mber, fo example from 180 to 188) >> to one of those motes as the destination address instead of bcasting >> them (I say this based on details in XSniffer). >> thanks for your answer though >> >> 2009/10/14 Michael Schippling <[email protected] >> <mailto:[email protected]>> >> >> >> Sounds like the BCASTing mote may not have been allowed >> into the mesh-fold yet. I haven't looked at XMESH carefully >> but it seems to take a while for nodes to become integrated. >> How long have waited for messages? >> >> MS >> >> Mohammad S. Hashemian wrote: >> >> Hi all, >> I have two MicaZ nodes and I've installed the same image of >> MTS310 XMesh application (from MoteWorks framework) on both. >> MoteView can receive and show health packet from one of >> them, but not from t other one. When I use XSniffer to sniff >> the network, I can see both of the motes send health packets >> but one of them send's the packet to the Base as >> destination, so the moteView can show it, butthe other one >> sends the packet as a broadcast and therefore the MoteViiew >> is unable to show it (it might not be the resaon though, but >> it's the only difference between the packets these two motes >> send). Considering that the sapacket is installed on , doe >> anyone have any idea what is the problem? >> Thanks, >> >> -- Mohammad S. Hashemian >> Research Scholar/DISCUS Lab >> Department of Computer Science >> 254.2 Thorvaldson Building >> University of Saskatchewan >> (306)966-1947 >> >> >> >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> Tinyos-help mailing list >> [email protected] >> <mailto:[email protected]> >> >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >> >> >> >> >> -- Mohammad S. Hashemian >> Research Scholar/DISCUS Lab >> Department of Computer Science >> 254.2 Thorvaldson Building >> University of Saskatchewan >> (306)966-1947 >> >> >> >> >> -- >> Mohammad S. Hashemian >> Research Scholar/DISCUS Lab >> Department of Computer Science >> 254.2 Thorvaldson Building >> University of Saskatchewan >> (306)966-1947 >> >> -- Mohammad S. Hashemian Research Scholar/DISCUS Lab Department of Computer Science 254.2 Thorvaldson Building University of Saskatchewan (306)966-1947
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
