Hello Giri,
Thanks for the reply to my question.
I use TOSBase.nc,v 1.1.4.1 2007/04/26 19:37:11 for the xmesh application. I now
get the valueof the ADC since I added "ADC0" to the printing section at the
corresponding XML file. I used the xmesh application with TOSBASE at the
gateway and xserve at the PC.
But at the XSensor application I still have no output when I use the xserve
application on the PC.
I did not used the XMeshBase because I try to run the xsensor application (not
a xmesh).
It is a little bit confusing for me that there exist a XMeshBase application
while TOSBase can handle the xmesh message but not the XSensor messages.
Maybe you can bring some light into the darkness. As you probably can see I am
a newbie at this topic.
Thanks
Daniel
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
